IFM Electronic Ecomat200 Monitor FD-1 Betriebsanleitung Seite 36

FD-1/FD-1N
MONITOR
3. Unit description
Operating and indicating elements
Display
1
(7/14 segment)
LEDs In 1 and In 2 (yellow): signal input pulses
2
Only for FD-1 N: LED Err (red): comes on if there is a fault of the pulse pick-up cable
(at the same time the channel indicator of the faulty input flashes)
Setting buttons: selection of parameters, setting of parameter values, selection of the actual value
3
display
Programming button: selection of the operating mode, storage of the parameter value,
4
front reset
5
LEDs: signal the output state
6
Panel for labelling
page 36
CH1 CH2 CH3 CH4 RUN PRG TST KEY
1b
1 2 3
7 8 9
MONITOR FD-1 N
Frequency/Direction
CH1 CH2 CH3 CH4 RUN PRG TST KEY
In 1
In 2
Err
13 14 15
19 20 21
Indicators:
CH1 ... CH4 = indicators for input channels (here: CH1 and CH2)
RUN = indicator for the normal operating mode
1a
PRG =indicator for the programming mode
TST = indicator for the test function
KEY = indicator for the unit status (locking)
1b Numerical display for actual values and the parameter values (5 digits)
1c Alphanumeric display for parameter abbreviation and units (3 digits)
1a
1c
4 5 6
10 11 12
1
2
3
4
Out1
Out2
5
6
16 17 18
7
22 23 24