IFM Electronic Ecomat200 Monitor FD-1 Betriebsanleitung Seite 48

FD-1/FD-1N
MONITOR
By pressing the push-buttons
When the highest or the lowest parameter has been reached, you return to the step-
ping parameter of the column.
By pressing the
press the push-button once, you get from one of the measured values of column 0
to the stepping parameter of column 1, by pressing the push-button again briefly
you get to the stepping parameter of column 2. By pressing the push-button once
again you get back to column 0 (to the measured value displayed before).
NOTE:
• At any place within the columns 1 or 2 (it is not important whether on a setting
parameter or the stepping parameter), you get back to column 0 by pressing the
push-button for approx. 3s.
• When the display shows a setting parameter, you return to the programming mode
(to change the parameters) by pressing the
• When no push-button is pressed for approx. 15s, the unit returns to the Run mode
(column 0, last measured value).
4. Programming
When making any alterations to the monitor it is advised to stop the machine
or plant as any changes accepted by the monitor will have immediate effect
on the operation of the monitor.
Default back to basic factory settings (Factory Reset)
The basic settings made in the factory can be re-entered by pressing
taneously while power is applied. All the parameters you entered are lost.
Locking / Unlocking
The unit can be locked so that unintentional incorrect entries can be avoided:
Press the push-buttons
tor is flashing.
Release the push-buttons when the indicator is constantly lit in the display.
For unlocking press the push-buttons
"KEY" indictor is flashing.
Release the push-buttons when the indicator is no longer displayed.
page 48
and
push-button you move right or left to another column: When you
and simultaneously and hold them. The "KEY" indica-
you can move up and down within a column.
push-button briefly.
and simultaneously and hold them. The
and simul-