IFM Electronic Ecomat200 Monitor FD-1 Betriebsanleitung Seite 47

Parameter table /Navigating
The adjustable parameters are stored in the unit in the form of a table. Column 1
contains the parameters for output 1, column 2 the parameters for output 2.
Column 0 contains the current measured values displayed in the RUN mode. The
number behind the parameter abbreviation (e.g. FO1 or FO2) shows you which
column is active at the moment.
A special field in each column is used to move from the current to the following
column (stepping parameter). In the display the number of the output, arrow
symbols and the letter P are indicated: The parameters above this field are
system parameters (usually they are only set during commissioning). The para-
meters below this field are application parameters which are set/changed more
often.
RUN
mode
actual
value
output 1
in RPM/Hz
actual
direction
*only for FD-1 N
** a) Changeover to the RUN mode b) Changeover to the test parameters if the test function is active
DISPLAY mode
DIM
EVM
NC1
SC1
ST1
FW1* FW2*
SO1 SO2
FO1 FO2
CT1 SP2
DT1 HY2
ST2
FT1
DT2
FT2
MONITOR
TEST mode
only accessible if
the test function
is active
(see page 24)
SW1
RUN
RUN**
Test
TS1
TP1
FD-1/FD-1N
page 47