B+B Taiga Bedienungsanleitung Seite 38

Taiga
| Electric Wheelchair
4.4. Summary
Push handles
Backrest
R-Net controller
Seat cushion
Electrical leg rests
Kerb climber
Fully electrical
VR-2 controller
Arm rest
Side part
Front light
Rear reflectors
Mechanical leg rests
Drive wheels
Steering wheel
Standard configuration
74
5. Settings
5.1. Basic settings
It is necessary to adjust the wheelchair to your body size before first use.
This is the only way to ensure a physiologically correct posture allowing
for long drives without tiring. Below you find a description of the basic
settings of the wheelchair. You should carry out these adjustments with
the help of your medical supply dealer. You need a set of 5 mm to 8 mm
Allen keys.
Make sure to always use two screws for secure faste-
ning!
5.1.1. Mechanical footrests
Length of lower leg supports
• The lower leg supports can be adjusted from 470 to 550 mm.
• To do so, loosen the two Allen screws (fig. 03).
• Adjust to the desired height.
• Tighten the screws again. Use medium-strength Loctite for fixation.
Angle of footrest
• The angles of the footrests are adjustable in 25° steps.
• Loosen the screwing at the side of the footrest.
• Adjust to the desired angle.
• Tighten the screw again. Use medium-strength Loctite for fixation.
2.
Bischoff & Bischoff GmbH | 2024 - 03 - 21– Revision: 2
Taiga
Electric Wheelchair |
3.
4.
75