Endress+Hauser iTEMP TMT85 Bedienungsanleitung Seite 43

TMT85
5.2.2 Display symbols
Item Function
No.
1 Displays the TAG
2 'Communication' symbol
3 Unit display
4 Measured value display
5 Channel display C1 or C2, P1, S1
6 'Configuration locked' symbol
7 Warning or error message
5.3 Configuration of the measuring device and FF functions
The FF communication system will only function properly if correctly configured. You can obtain
special configuration and operating programs from various manufacturers for the configuration.
Process control systems
Endress+Hauser ControlCare
Emerson DeltaV
PACTware
Rockwell
Control Logix/FFLD
Honeywell
PKS Experion
Yokogawa
Centum CS3000
!
Note!
A detailed step-by-step description of the procedure for commissioning the FF functions,
together with information on configuring device-specific parameters, is given in the Operating
Instructions on the CD-ROM provided.
Endress+Hauser
Description
TAG, 32 characters long.
The communication symbol appears when read and write-accessing
via the FOUNDATION Fieldbus™ protocol.
Unit display for the measured value displayed.
Displays the current measured value.
e.g. C1 for a measured value from channel 1.
The 'configuration locked' symbol appears when configuration is
locked via the hardware.
If a warning occurs, the display alternates between the measured
value and the warning code. If an error occurs, the display
alternates between the error code and "- - - -" (no valid measured
value available).
Detailed instructions are provided in the Operating Instructions on
the CD-ROM provided.
Asset management systems
National Instruments NI-Configurator (≥ 3.1.1)
Emerson AMS and Handheld FC375
Operation and commissioning
43