Endress+Hauser iTEMP TMT85 Bedienungsanleitung Seite 45

TMT85
Fig. 10: Hardware settings via DIP switches
1 Connection to head transmitter
2 DIP switch (1 - 64, SW/HW and ADDR ACTIVE), no function
3 DIP switch (SIM = simulation mode; WRITE LOCK = write protection; DISPL. 180° = switch (turn) the display
180°)
5.5 Switching on the measuring device
Once the final checks have been successfully completed, it is time to switch on the supply
voltage. The head transmitter performs a number of internal test functions after power-up. As
this procedure progresses, the following sequence of messages appears on the display:
Step Display
1 Display name and software (SW) and hardware (HW) version
2 Company logo
3 Device name (TMT85) as well as the SW, HW and device release of the head transmitter
4a The current measured value or
4b The current status message
!
If the switch-on procedure fails, the appropriate status message is displayed, depending on the cause. A
detailed list of the status messages, as well as the measures for troubleshooting, can be found in the
Operating Instructions on the CD-ROM.
The device is operational after approx. 8 seconds and the attached display after approx. 12
seconds! Normal measuring mode commences as soon as the switch-on procedure is completed.
Various measured values and/or status values appear on the display.
For a more detailed temperature transmitter configuration description and further information,
please refer to the Operating Instructions on the CD-ROM provided.
Endress+Hauser
Note!
Operation and commissioning
a0008326
45