Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.2. DOCKING STATION INSTALLATION
Once you have determined where to place the equipment, follow the instructions below to properly install
the docking station.
The Holster should be mounted a minimum of 90cm (35") above the floor, or in such a way to ensure the
monocoil cable does not lie on the floor. It is recommended to mount the docking station inside a cabinet,
under a countertop or on the wall in order to conserve precious counter-space.
CAUTION: If you're installing the docking station in an enclosed cabinet, consider that the docking
station and the power supply must dissipate 150 watts of heat continuously while operating.
Maintain a clearance of at least three inches from the back of docking station in order for the fan to
function properly.
Remove the Concept IV
All wiring connections are accessible on the back panel, therefore, for desktop installation, it is not
necessary to remove the cover. For mounting the Concept IV
countertop or on the wall, it is necessary to use the supplied mounting bracket. The first step necessary to
access the mounting brackets is to remove the cover. Follow the instructions below for removing the
cover.
Release the Mounting Bracket ------------------------------------------------------------------------------------
FWT
The Concept IV
docking station can be wall
mounted or set under a countertop. The
mounting bracket is included as part of the basic
system, and is attached to the bottom of the
docking station at time of shipment. For
Mounting Plate Retaining Screws
FWT
AcuCam Concept IV
FWT
Cover--------------------------------------------------------------------------------
The Cover
Release the docking station cover by grasping the left
and right bottom edge of the cover. Pull both edges
outward and gently lift the cover.
15
FWT
docking station into a cabinet, under a
countertop installations the wall bracket can be
removed, however it is not necessary. If you do
remove the bracket, it is recommended that you
save it for future use.
The Brackets
To release the mounting brackets, locate the two
retaining screws on both sides of the docking
station chassis.
Lateral view of Docking Station
Operation Manual and Installation Guide
Werbung
