Disposal - Dometic POWER & CONTROL SC330 Montage- Und Bedienungsanleitung

EN
Problem
The solar charge controller does not
work. The status LED of the house bat-
tery (B1) is flashing red.
The solar charge controller does not
work. The two LEDs (B1 and B2) are
flashing red.

13 Disposal

Recycling packaging material: Place the packaging material in the appropriate recycling waste bins wher-
ever possible.
22
Possible cause
The solar system does not work prop-
erly (low power output). Objects or
dirt are blocking out light.
Overheating of the solar panels.
One solar panel in the array failed.
Short circuit has been generated.
Only LiFePO4 batteries: Temperature
sensor is not connected.
The device fuse is defective.
Suggested remedy
Check for obstructions and en-
sure that the solar panels are not
blocked by shadows.
Move the vehicle to a more suit-
able location.
Remove any dirt.
Allow the solar panels to cool
down.
Move the vehicle to a more suit-
able location.
Ensure sufficient air circulation
around the solar panels.
Pull out the fuse on the solar
charge controller and check the
solar panel voltage (VoC) on the
solar charge controller.
Check the solar panels for micro
cracks.
Check the solar panels for de-
lamination.
Replace the defective solar panel
if necessary.
The device fuse must be re-
placed after it has been trig-
gered by excess current (see
chapter Replacing the fuse
page 21).
Let the fuse be replaced by quali-
fied personnel only.
Only LiFePO4 batteries: Connect the
temperature sensor.
The device fuse must be re-
placed after it has been trig-
gered by excess current (see
chapter Replacing the fuse
page 21).
Let the fuse be replaced by quali-
fied personnel only.
on
on