Parkside PKS 2200 A1 Originalbetriebsanleitung Seite 51

With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly, the saw chain will spray a
little oil off after starting.
Turn the chain bar
F
Use cut-protection gloves when han-
dling the chain or the chain bar.
The blade (4) has to be reversed regularly
after a working time of approximately 10
hours in order to ensure even wear.
1. Switch off the saw and pull out the
power plug (
A
2. Remove the sprocket chain wheel cov-
ering (8), the saw chain (5) and the
chain bar (4).
3. Turn the blade around its horizontal
axis and install the blade and chain as
described under "Installing the sawing
chain and blade".
When doing so, pay attention to the
correct rotation direction of the saw
chain!
Use the graphical symbol below the chain
sprocket cover (8) as a guide to the align-
ment of the saw chain (5) when the blade
is rotated. The illustrated direction of travel
on the blade is no longer true.
Storage
• Clean the device prior to storage.
• Empty the oil tank prior to longer peri-
ods of non-use. Dispose of used oil in
an environmentally-responsible way (see
„Disposal/Environmental Protection").
12).
Direction of travel of the
saw chain
• Attach the protective blade cover.
• Store the device in a dry and dustproof
location and out of reach of children.
Waste disposal and
environmental protection
Empty the oil tank before disposing of the
device.
Do not dispose of used oil in the sewage
system or drains. Dispose of used oil in an
environmentally correct manner - bring it to
a waste disposal center.
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Machines do not belong with
domestic waste.
The crossed out waste bin symbol
means that this product must not be
disposed of with household waste
after its service life.
Directive 2012/19/EU on waste electrical
and electronic equipment: Used electrical
devices must be collected separately for
disposal and recycled in an environmen-
tally sound manner.
Depending on implementation in national
law, you may have the following options:
• Return to a shop,
• Hand over to an official collection
point,
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
GB
51