Parkside PKS 2200 A1 Originalbetriebsanleitung Seite 43

Chain lubrication
The rail and chain must never be
without oil. If you operate the elec-
tric chainsaw with too little oil, the
cutting performance and the lifetime
of the saw chain is reduced, since
the chain becomes blunt faster. You
can identify a case of too little oil
where smoke development or dis-
coloration of the rail occurs.
As soon as the motor is speeded up, the oil
also flows faster to the chain bar (
Filling up with chain oil:
• Check the oil level indicator (
regularly and top-up the oil if the mini-
mum mark „MIN" (
on the oil level indicator. The oil tank
holds about 250 ml of oil.
• Use Parkside bio-oil; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center.
• If you have no bio-oil available, use
chain lubrication oil with low adhesive
additive content.
Use only the recommended lubricant.
• Empty the oil tank before longer peri-
ods (6-8 weeks) of non-use.
1. Unscrew the oil fill cap (2) and fill
C
up with chain oil.
2. Wipe off any spilled oil and
close the cap (2) again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.
4).
A
21)
C
22) is reached
C
Operating the chainsaw
Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled. Ensure the voltage of the
mains connection agrees with the
label on the device. Make sure you
have a secure stance. Make sure be-
fore you start that the electric chain
saw is not touching anything.
Caution! Saw can oil up, see notes
on "Assembly - Mounting the saw
chain and blade"
D
Switching on
1. Check before the start, whether suffi-
cient chain oil is in the tank and, if nec-
essary, refill with chain oil (see Chapter
Operation Startup).
2. Make a loop in the end of the exten-
sion cable and hook it into the strain
relief (11) on the rear handle (1).
3. Connect the device to the mains voltage.
4. Release the chain brake, where you
shift the brake arm (3) back against the
front grip (16).
5. Hold the electric chainsaw firmly with
both hands, with the right hand on the
rear grip (1) and the left hand on the
front handle (16). Thumb and finger
must close securely over the handles.
6. For switching on, activate the switch-on
block (14) with the right thumb and then
press the On/Off switch (13), the elec-
tric power saw runs with highest speed.
Release the switch-on block (14) again.
7. The power saw switches off when you
release the On/Off switch (13) again.
Switching for continuous running is not
possible.
GB
43