Parkside PKS 2200 A1 Originalbetriebsanleitung Seite 41

A
Safety functions
1 Rear grip with hand guard (10)
Protects the hand against branches and
boughs in the case of springing away
by the chain.
3 Chain braking lever/
hand guard
Control system, which stops the saw
chain immediately in case of a spring-
back; lever can also be activated
manually; protects the left hand of the
operator if it slides from the front grip.
The motor cannot be turned on if
the chain brake has engaged.
5 Saw chain with small spring-
back
Helps you to catch spring-backs with
specially developed control systems.
17 Metal stop claw
Reinforces the stability when vertical cuts
are carried out and facilitates sawing.
15 Electric motor
Double insulated for safety reasons.
13 On-off switch with safety chain
brake
On releasing the On/Off switch, the
device immediately switches off.
14 Switch-on block
The switch-on block must be released
for switching on the device.
18 Chain catcher
Decreases the danger of injuries
chain breaks or if it comes off.
Assembly
Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself – injury hazard!
Before putting the electric chain saw into
operation, you must:
- install the blade, saw chain and chain
cover where necessary,
- adjust the saw chain tension,
- pour in chain oil,
- check the function of the chain brake
and the automatic oil pump.
Mounting the saw chain
and blade
1. Lay the saw on a flat surface.
2. Turn the fastening bolt (14) anti-
clockwise (
sprocket chain wheel covering (8).
3. Spread the chain (5) out into a loop
with the cutting edges running clock-
wise .
4. Slide the saw chain (5) into the bar
guide groove. To mount the guide bar
(4), raise it to an angle of approx.
45 degrees. This will make it easier
to replace the saw chain (5) onto the
if the sprocket (24).
5. Place the chain bar (4) and saw chain
(5) on the bar bolts (23). When the
nose on the right below the bar bolt
(23) sits in the round recess on the
blade, the blade is placed correctly. It is
normal for the saw chain (5) to sag.It is
normal that the saw chain (5) is slack.
6. Pre-tension the saw chain (5) by turning
the screw for the chain quick-tensioning
GB
) to remove the
41