Parkside PKS 2200 A1 Originalbetriebsanleitung Seite 40

GB
a) Cuts
b) Ear damage if working without ear pro-
tection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and
the manufacturer of their medical
implant before operating the ma-
chine.
Further safety directions
• If the supply cord of this power tool
is damaged, it must be replaced by
a specially prepared cord available
through the service organization.
• If it is necessary to replace the connec-
tion cable, we recommend that this be
performed by the manufacturer or an
authorised representative (e.g. author-
ised workshop, customer service, etc.).
• Lay the extension cable in such a way
that it will not be caught by branches
or similar during sawing.
• Use a RCD (Residual Current Device)
with a rated residual current of 30 mA
or less.
• Comply carefully with maintenance,
control and service instructions in this
manual.
Damaged protective devices and parts
have to be repared or changed except
40
as noted otherwise in this manual.
• It is recommended that a first-time user
at least practice the cutting of logs on a
saw log or frame.
• Use only approved mains cables of
type H05RN-F that are not more than
75 m long and that are designed for
outdoor use. The wire cross section
of the mains cable must be at least
2.5 mm
2 . Always roll out the cable reel
completely before use. Check the mains
cable for damages.
• Warning! During operation, this power
tool produces an electromagnetic field.
Under certain circumstances, this field
may negatively affect active or passive
medical implants. In order to reduce
the danger of serious or fatal injuries,
we recommend that individuals who
wear medical implants should consult
their doctor and the manufacturer of
the implant before operating the ma-
chine.
• For sowing work on hillsides, always
stand in the area above the log. To
keep total control while sawing through,
reduce the pressure at the end of the
cut without loosening your grip on the
handles of the electric chain saw. Make
sure the saw chain does not touch the
ground. After finishing the cut, wait until
the electric chain saw comes to a halt
before removing it. Always shut off the
engine of the electric chain saw before
switching between trees.
• Dirt, stones, loose bark, nails, clips and
wires must be removed from the tree.
• Follow the maintenance, control and ser-
vice instructions in this manual carefully.
Damaged safety equipment and parts
must be repaired or replaced profes-
sionally by our service centre, unless
otherwise indicated in the operating
instructions.