General Information; Abbreviations And Subject Index; Scope Of Delivery - Bwt Roc Clinic One Einbau- Und Bedienungsanleitung

1

General information

1.1

Abbreviations and subject index

Softener:
Raw water:
RO:
Permeate:
Concentrate:
Membranes:
TDS:
SDI:
Conductivity,
electrical conduc-
tivity:
IOM:
Permeate yield
(WCF):
Bypass setting
with cold drinking
water:

1.2 Scope of delivery

The following components are included in the scope of delivery of the RO device:
■ bestaqua 14 Membrane RO filter cartridge
■ bestdemin Plus demineralisation system
■ Installation and operating instructions
■ Connection material: Connection cable for the power supply (type F / type I / type G), ad-
aptor 3/4" x 10 mm push-in, adaptor 3/8" x 8 mm push-in, concentrate flow restrictor 8 mm
push-in, elbow connector 8 mm push-in.
The following components of the RO device can be seen on the front:
1 bestaqua 14 Membrane RO filter cartridge
1
2 bestdemin Plus demineralisation system
3 LED status
4 Top service cover
The following connections can be seen on the rear of the RO device:
5 Device ON/OFF switch
2
6 PE mains plug type IEC 320
7 Feed water connection 3/4"
8 Concentrate connection 8 mm JG (5/16")
9 External tank connection 8 mm JG (5/16")
10 Permeate connection 3/8"
11 Technical data for the RO device
The water purification process removes the hardness from raw water. Hard-
ness constituents are the portion of calcium and magnesium ions in the water.
The raw water is the untreated drinking water that is connected to the water
inlet.
Abbreviation for reverse osmosis.
This is "pure water" that has been largely desalinated by reverse osmosis.
The characteristic value is the electric conductivity in µS/cm.
This is waste water containing the salts and minerals that have been removed
from the raw water.
The "filter" of the device which is capable of desalinating the raw water by
high pressure and flow.
Total Dissolved Solids: Total content of dissolved salt, measured in mg/l.
Silt Density Index: The "Silt Density Index" is a measure for the level of inlet
water impurity.
The smaller the value of the electrical conductivity measured (in μS/cm) by the
RO device, the lower the salt concentration in the permeate product.
Abbreviation for "Installation and Operating Manual"
The ratio between the amount of pure water (permeate) produced and the
waste water produced. WCF stands for Water Conversion Factor.
The bypass settings on the filter head have no function for this filter cart-
ridge. The bypass setting of the bestdemin Plus must always be set to the 0
position for the device to function properly.
19