Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLESHOOTING
Sound is distorted.
¢ There's noise on the tape you're recording from.
| ® Use another tape.
¢ Recording level is too high.
e Lower the recording level.
© Dirty head.
e Clean head (see page 35).
Sound wavers.
* Head, pinch roller, capstan are dirty.
e Clean (see page 35).
© Cassette tape isn't perfectly wound.
e Rewind or fast forward to wind tape correctly.
There's a lot of noise.
¢ You're using a tape with a lot of noise on it.
e Use another tape.
® Recording level is too low.
e Raise the recording level.
© Head is dirty.
¢ Clean head (see page 35).
¢ Head is magnetized.
¢ Demagnetize the head with a head demagnetizer.
© Imperfect connection of cords.
® Check all input/output connections and make
sure cords are firmly plugged in.
Music search does not work.
© No 4-second space between songs.
e Use tape with 4-second spaces between songs.
A.S.E.S. doesn't work. (''Err'' is | ¢ Not enough conditions are met for A.S.E.S.
e Refer to CD player operating instructions.
displayed on the cassette deck
operation.
display.)
Tuner
No reception
e Antenna not connected.
¢ Connect antenna correctly.
¢ Wrong radio band.
© Set to desired radio band.
;
e Station not tuned in.
e Tune in station.
e Amplifier input selector not set to TUNER.
e Set input selector to TUNER.
Beat noise heard.
.
¢ TV is on.
¢ Turn off TV or move away.
e Loop antenna is at bad position.
© Set loop antenna to better position.
Noise heard.
e Interference from nearby fluorescent light, hair
e Stop using device causing interference.
dryer, or other electrical appliance.
¢ Not tuned in correctly.
e Use other controls to tune in station.
Sound distorted.
e Antenna in poor position.
e Change antenna to position that does not cause
distortion.
¢ Broadcast is weak.
¢ Use external antenna.
© Interference from other electrical devices or
e Change supplied antenna position.
multipath reception.
¢ Input signal is too strong.
¢ Switch LOCAL ON.
© CD player cord is too close to the antenna cord.
¢ Keep CD player cord and antenna cord as far
away from each other as possible, or switch off
power to CD player.
Stereo FM broadcasts not in
¢ Signal is too weak, antenna input is insufficient.
¢ Use an multi-element outside antenna instead.
stereo.
© MPX mode is MONO.
¢ Cancel MONO mode with the FM MONO switch.
Clock and Timer
No time indication
¢ There was a power blackout.
e Set time again.
© AC plug was pulled.
© Set time again.
Timer does not work.
e Current time is not set.
e Set current time.
¢ Start and/or stop time is not set.
¢ Set ON and OFF times.
¢ Timer is not on.
¢ Operate TIMER CHECK switch and TIMER
ON/OFF switch to switch timer ON.
Remote Control Unit
Remote control does not work.
e Batteries are dead or no batteries in remote
e Insert new batteries.
control unit.
© Poor angle or too great a distance from the
e Use within seven meters and within a 30 degree
remote sensor window.
angle of the remote sensor window.
e There is an obstacle between you and the remote | ® Change your position or move the obstacle.
sensor window.
e A fluorescent light is shining on the remote
® Move so fluorescent light does not shine directly
sensor window.
on amplifier front panel remote sensor window.
37
<ARE1137>
En
Werbung
