Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting
a turntable
Plug the output cable of the turntable into
the PHONO jack of the amplifier, the L plug
into the left (L) jack and the R plug into the
right (R) jack.
If the turntable is equipped with a ground
wire, connect
it to the GND
terminal.
*
tf hum or other noise is produced when
the ground wire is connected, disconnect
'
it.
NOTE:
.
The amplifier cannot be used with MC
Turntable (MM cartridge)
cartridges
directly.
Use
a separate
head amplifier or step-up transformer.
Connecting a CD player
Use pin plug cords to connect the analog
output jacks of the CD player to the CD jacks
of the amplifier.
CD player
ANALOG
OUTPUT
Connecting
a tuner
Use pin plug cords to connect the output
jacks of the tuner to the TUNER jacks of the
amplifier.
DAT (for recording and playback)
|
ct ce
ere
rr
00
rer eem
0
Connecting
a DAT
(Digital Audio Tape Recorder)
Connections for recording: Connect the DAT's analog recording input jacks (LINE
IN or REC) to the amplifier's tape recording (OUTPUT) jacks using pin plug cords.
Connections for playback: Connect the DAT''s analog playback output jacks (LINE
OUT or PB) to the amplifier's tape playback (INPUT) jacks using pin plug cords.
or other noise.
e Be sure to connect the left and right
channels properly (left
introduction of hum
Tape deck
e
MONO
Use these jacks to con-
nect a subwoofer with a
built-in amplifier (super-
woofer), etc.
<x{
IG)
Connecting
tape decks
Connections for recording: Connect the tape deck's
recording
input jacks (LINE
IN or REC)
to the
amplifiers tape recording (OUTPUT) jacks using
pin plug cords.
Connections for playback: Connect the tape deck's
playback
output
jacks (LINE
OUT
or PB) to the
amplifier's tape playback (INPUT) jacks using pin
plug cords.
Xx
alll
Center speakers
a
POWER
OUTLET
'
>
&
AC 230 V, 50 Hz
5 |
Ut
}
Rear L
Rear R
Front L Front R
LEY
A
UL d
—
+
-
+
=
+
=
+
Rear speaker system
(surround)
Front speaker system
Connecting speaker systems
e
Precautions when connecting speakers
If a speaker is placed neas a TV or video monitor, the colors
Connect the speaker systems for the left chan-
on the screen may be disturbed by the speaker's magnetism.
nel (the left side as seen from the front) to the L
If this should happen, move the speaker away to a position
terminals, and the speaker systems for the right
where it does not have this effect.
channel
to the R terminals.
Werbung
