Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Initial settings of parameters
The initial settings of the different parameters are as shown
below.
When the CLEAR button is pressed, the settings are all reset to these values.
SP/PRE | SP/PRE
SP
LEVEL | LEVEL
MODE
LOGIC
TONE
TIME
awe
on | or Dor [ee -
P=
| - | -
fasion
ow | ow [ree [zee [| - if
ie aes a
pee
en con
eS an
Co ee ECE a
ee
oo
| ON | OF
| ON
| ON |
| ON |
ae
|_2imsee
| 2imsee |
LON | -1248
| 2imsec_|
pon | = |
cone
owas
ce
pore
| on | -
| on | =
eONed oe
ON lee
STADIUM
MATRIX
ve
SURR.
INIT
ROOM
EFFECT
EFFECT
SIGNAL
DELAY
SIZE
LEVEL
ON/OFF
AVSE
CINEMA
lawson
Sd
wove
=
ae Po
fesse
SCC
ae ft
roe ree
f o f
fewach
SiC ee |
uae tee |
[= [ase [16
ee
ee
ewe
om
neo
a
0
OFF
OFF
STADIUM
MATRIX
fio] LAST FUNCTION MEMORY
e This amplifier is equipped with a last function memory which stores the input and output setting conditions as they were
immediately
before the power is switched
off.
This function
eliminates the need to perform complicated
resettings when
the power
is switched
on.
@ This amplifier is also equipped with a back-up memory. This function provides approximately one month of memory
storage
with the power
cord disconnected.
[11] SPECIFICATIONS
e Audio Section
(Power ampiifier)
Rated output:
(All properties shown are
only for the power
amplifier stage.)
Load Impedance:
(Pre-amplifier)
Front:
80W+80W
(20 Hz to 20 kHz 8 ohms 0.05% T.H.D.)
Center:
80W
(20 Hz to 20 kHz 8 ohms 0.05% T.H.D.)
Rear:
25W + 25W
(1 kHz, 8 ohms, 0.5% T.H.D.)
Front:
6 to 16 ohms
Center:
6to 160hms
Rear:
6 to 16 ohms
Line input (Each line input - FRONT PRE OUT)
Input sensitivity /impedance:
Frequency response:
Tone control range:
Signal-to-noise ratio
Distortion factor:
150 mV/47 k ohms
PHONO (MM): 2.5 mV / 47 kohms
10 Hzto50kHz:
+3dB (BYPASS mode)
5 Hzto 100 kHz:
+0,-3dB (CD DIRECT)
BASS:
+10dB at 100 Hz
TREBLE:
+10 dB at 10 kHz
92 dB (BYPASS mode)
94 dB (CD DIRECT)
0.01% 1 kHz 1 V (BYPASS mode)
Phono equalizer (PHONO input — REC OUT)
RIAA deviation:
Signal-to-noise ratio:
Rated output /Maximum output:
Distortion factor:
e
Video Section
Standard video jacks
input and output level /impedance:
Frequency response:
S-video output jacks
Input and output level /impedance:
Frequency response:
e
General
Power supply:
Power consumption:
Maximum external dimensions:
Weight:
e
Remote control unit
+1 dB (20 Hz to 20 kHz)
74 dB (A weighting, with 5 mV input)
150 mV/8V
0.03% (1 kHz, 3 V)
1 Vp-p/75 ohms
1 Hz to 8 MHz +0, -3 dB
Y (brightness) signal: 1 Vp-p/75 ohms
C (color) signal: 0.286 Vp-p/75 ohms
1 Hz to 10 MHz +0, -3 dB
AC 230 V, 50 Hz
250 W
434 (W) x 161 (H) x 421 (D) mm (17-3/32" x 6-11/32" x 16-37/64")
12.7 kg (28 Ibs 1 02)
System remote control with learning function
RC-163:
Total buttons:
62
DENON system code
DAT:
8 buttons
CD player:
8 buttons
Cassette deck:
8 buttons
VDP:
8 buttons
TUNER:
2 buttons
AVC-2530 fixed codes: 38 buttons
Learning buttons
System call buttons: 3 (maximum of 10 codes per button)
Program — AMP: 14 buttons
— AV: 58 buttons
Maximum total:
35 codes
Batteries:
R6P/AA Type (two batteries)
External dimensions:
70 (W) x 215 (H) x 18 (D) mm (2-3/4" x 8-15/32" x 45/64")
Weight:
170 g (Approx. 6 02) (including batteries)
* For purposes of improvement,
specifications and design are subject to change without notice.
23
Werbung
