Denon AVC2530 Bedienungsanleitung Seite 11

[5]
REMOTE CONTROL UNIT
@i Cautions for batteries
Be sure that the @ and © ends of the batteries
match the marks on the battery case of the remote
control unit.
Replace weak batteries as soon as possible.
Do not mix new batteries with used ones.
Do not use batteries of different types together. Note
that some batteries of the same shape and size may
provide different performance.
Some batteries are rechargeable, others are not.
Read the battery instructions carefully.
Do not connect the @ and © ends of the batteries
directly with metal objects. (Do not short-circuit the
batteries.)
Do not disassemble, heat, or dispose of batteries in a
fire. If the batteries should leak, carefully wipe off
any fluid from the battery case, then insert new
batteries.
MB Using the remote control unit
The remote control unit uses highly linear infrared rays.
Point it at the amplifier's remote sensor when operating
it. The amplifier will not operate if the remote sensor is
covered or if there is an obstacle between the remote
control unit and the sensor.
Also note that strong light shining on the remote sensor
may result in mistaken operations. In addition, using
the amplifier near neon signs which generate pulse
type noise may result in mistaken operations, so keep
the amplifier as far as possible from such neon signs.
Ml Range of operation of the remote control unit
1. Open the bottom cover of the remote control unit and
remove the battery cover.
2. Insert the two R6P/AA batteries, matching the @ and
© marks on the batteries with those in the case.
A note on battery replacement
Have replacement batteries on hand so that the old
batteries can be replaced as quickly as possible when
the time comes.
The codes that have been learned may be lost if
removed batteries are not replaced within about 5
minutes.
Point the remote control unit at the remote sensor when
operating it, as shown on the diagram.
The remote control unit can be used at a direct distance of
approximately 7 meters from the main unit, though this
distance will be shorter if there is an obstacle between the
remote control unit and main unit or if the remote control
unit is operated from an angle.
=» Continued
Part names and functions of the remote control unit
AVC-2530 codes
UNIVERSAL REMOTE CONTROL UNIT
00 bo (OLY SURROUND]
PRO-LOGIC
AVC-2530 Codes
Use with the PROGRAM switch @ set to the AMP side.
2)
Transmitting window
The remote control signals (infrared rays) are sent
from this window.
Indicator section (START, LEARNED / TX)
System codes
START
MODEL AC-163 LEARNED te
DENON
UNIVERSAL REMOTE CONTROL UNIT
00 jeourY suRROUD)
PRO -LOGIC
@ USE/LEARN
(normal use/learn mode) selector button
Press this button with the tip of a pen, etc., to set the
learn mode. Both the START and LEARNED/TX
indicators in the indicator section @ flash and codes
can be learned.
@ PROGRAM switch
11