Carl Valentin Dynacode IP53 Kurzanleitung Seite 137

Key:
Input
Key:
Output
Diagnostic
Key:
Encoder profiling
Key:
Roller diameter
Key:
Encoder average
Key:
I/O status
Key:
Online/Offline
Indication of level for IO parameters input.
0 = Low
1 = High
Indication of level for IO parameters output.
0 = Low
1 = High
Press key to access the diagnostic menu.
The encoder values with print start in logging files are registered on CF card. By means of this
data, a graphic chart of the encoder curve can be created.
DiaRW = Diameter of transfer ribbon rewinding roll.
DiaRU = Diameter of transfer ribbon unwinding roll.
Number of values by which the encoder signals is averaged. The more higher the value the
more slowly react the device to speed modifications.
Relevant results are counted and registered in RAM memory. The protocole get lost after
switching off the device.
IgnrStrt = Counter for ignored start signals.
IntPrts = Counter for cancelled print orders.
With the cursor select the value of which you need more information and then press key
NJb =No job
Counter for ignored start signals because the print order was not active.
NRd = Not ready
Counter for ignored start signals because the print order was not ready (stopped or error
message).
Prt = Printing
Counter for ignored start signals, during the device prints/is active.
MS/I = Manual stopped/interrupted
Stop key onto foil keyboard, panel or in a program was pressed.
ItfI = Interface interrupted
The print order was cancelled because new data was received by an interface.
SpedS = Speed stopped
The print order was cancelled because the measured print speed was too slow.
This function is activated e.g. if the transfer ribbon is to be changed. It is avoided that a print
order is processed although the module is not ready. If the function is activated then press the
key to change between Online and Offline mode. The respective state is indicated in the
display (Standard: Off).
Online: Data can be received by interface. The keys of the foil keyboard are only active, if you
changed in the Offline mode with key
Offline: The keys of the foil keyboard are still active but received data are not processed. If the
module is again in Online mode then new print orders can be again received.
English
.
Dynacode IP
.
137