Starting Combi Mode (Pro B3 Only) - Sentiotec Pro B2 Montage- Und Gebrauchsanweisungen

Instructions for use for the user

9.6. Starting Combi mode (PRO B3 only)

1. Use the temperature selector
► The temperature selector
in the temperature display
2. Press the temperature selector
► The sauna heater is switched on and begins to heat up.
► The current temperature in the cabin is displayed in the temperature
display
4
3. Use the humidity selector
► The humidity selector
the humidity display
4. Press the humidity selector
► The vaporizer switches on.
► Then the current humidity in the sauna cabin is displayed in the humidity
display
1
humidity is displayed.
If the sauna control unit is used without a humidity/temperature sensor
(FTS2), cyclic mode is activated. If the sauna cabin temperature is less
than 30° C, the vaporizer is activated continuously for 10 minutes. This
ensures that the water in the tank reaches a basic temperature level.
Cycle mode then starts.
The vaporizer can only be started when the sauna heater is switched on.
The maximum humidity that can be set depends on the temperature of
the sauna. The higher the sauna temperature, the lower the maximum
humidity level which can be set – see characteristic curve on 12.
Exception: Vaporizer single mode is activated (see ). The vaporizer
can also be operated here without the sauna heater, with the maximum
humidity depending on the current sauna cabin temperature.
3
3
4
. In single-sensor mode, the preset temperature is displayed.
to set the preferred humidity.
2
flashes and the preset humidity is shown in
2
.
1
2
. If a humidity temperature sensor is not installed, the preset
to set the preferred temperature.
flashes and the preset temperature is shown
.
.
3
.
p. 30/38