Switching On The Sauna Control Unit; Starting Sauna Mode - Sentiotec Pro B2 Montage- Und Gebrauchsanweisungen

Instructions for use for the user

9.4. Switching on the sauna control unit

WARNING!
Risk of fire
Flammable objects that are placed on the sauna heater could ignite and
cause fires.
● NEVER place combustible objects on the sauna heater.
● Make sure that NO flammable objects have been placed on the sauna
heater before the sauna control unit is switched on.
● Press the ON/OFF switch
► "0" appears for a few seconds in the temperature display
current temperature in the sauna cabin is displayed. In single-sensor
mode, the previously set preset temperature is displayed.
► PRO B3 only: "0" appears for a few seconds in the humidity display
Then the current humidity in the sauna cabin is displayed. If a humidity
temperature sensor is not installed, the last preset humidity is displayed.

9.5. Starting sauna mode

1. Use the temperature selector
► The temperature selector
in the temperature display
2. Press the temperature selector
► The sauna heater is switched on and begins to heat up.
► The current temperature in the cabin is displayed in the temperature
display
4
You can change the preset temperature during operation any time.
● Turn the temperature selector
perature.
● Turn the temperature selector
perature.
► The temperature selector
is applied.
to switch on the sauna control unit.
6
3
flashes and the preset temperature is shown
3
4
3
. In single-sensor mode, the preset temperature is displayed.
3
to set the preferred temperature.
.
.
to the right to increase the tem-
3
to the left to decrease the tem-
3
flashes and the newly set temperature
p. 29/38
. Then the
4
.
1
EN