Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ing element adds up the periods during which the device was using
nominal electric power (during standard operation the device regu-
lates the temperature and uses very little power thanks to the fact
that it turns itself off for longer periods).
It can be checked at any time how much electricity has been used,
ie. during all day's operation. In practice it turns out to be up to
a few dozens of percent less!
1.
Meter reading:
Press and hold the
button — the display panel will show let-
ter E followed by 4 digits separated by a hyphen (actual oper-
ating time of the device), ie. E..0..2..-..1..5 means that the de-
vice was actually working for 2 hours and 15 minutes from the
last time the meter was zeroed.
2.
Meter resetting:
Press and hold the
button until E 00-00 comes up.
Remote mode operation (with IR transmitter)
Controller should start searching for an IR transmitter signal imme-
diately after it has been turned on – this is indicated by
ing on the display panel. Should this not happen, press and hold the
button until the
icon starts flashing. After being connected, the
icon will stay on and a dash will appear.
User Manual — Electric heating elements of the SKT series
94
The number displayed on the meter reflects the actual energy con-
sumption, therefore you can measure the actual cost of energy used
by multiplying the number on the meter by the nominal heating
output of the heating element and the price of electricity (1 kW).
Setting permanent local mode
The device has been designed to work in a set, therefore, it will start
searching for an IR transmitter signal immediately after being turned
on ( icon will start flashing). If the device does not find an active IR
transmitter, the diode will keep flashing. In order to turn it off, press
and hold the
button until the diode stops flashing which will
mean that the controller is no longer searching for the IR transmitter
and will keep working in the local mode only. In order to go back to
work with IR transmitter, press and hold the
When working in the remote mode, buttons
icon flash-
(except when using the Dryer Mode).
button.
and
are not active
Werbung
