Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Timer programming
Turn on the device by pressing .
Press and hold
→ button ON or OF will
start flashing
Activate (On) or deactivate (Of) the mode
with the use of
and
. Confirm by
pressing .
Clock field is flashing on the display pan-
el and T1 is on
Set the START of the first time zone with
the use of
and
. Confirm by press-
ing .
Set the START of subsequent time
zones T2 – T4 with the use of
and
Confirm by pressing .
Temperature field is flashing on the display
panel and T1 is on.
Set the required TEMPERATURE for T1
zone using
and
. Confirm by press-
ing .
Set the required TEMPERATURES for the
time zones T2 – T4.
Confirm by pressing .
User Manual — Electric heating elements of the SKT series
90
Attention: When the 24 hour TIMER is on, the user can temporarily change the
set temperature. When the TIMER starts its next preset program, all the manual-
ly changed settings will be cancelled.
While the 24 hour TIMER is on, it is possible to use the DRYER MODE — re-
gardless of the current device status and the set program, the device will start
operating at the DRYER MODE settings. When the DRYER MODE ends, the
device returns to the 24 hour TIMER mode. (refer to DRYER MODE section).
Anti-freeze mode
When the device is switched off with
mode) and remains connected to the mains, it will switch itself back on auto-
.
matically when the ambient temperature falls below 6°C, to prevent the heat-
ing agent from freezing. The display unit will show letters 'AF', until the anti-
freeze mode finishes, which is when the temperature rises above 6°C.
CALIBRATION OF TEMPERATURE
SENSOR
Calibration of the temperature sensor is done when the sensor indicates a tem-
perature that is different from the actual temperature inside the room. Values
that are too low or too high, as indicated by the sensor, can be adjusted within
-9 ... +9 degrees. The temperature correction value is set by pressing and hold-
ing the button
the required value is set. The set value will be added to the displayed temper-
ature, correcting its value.
Display panel is no longer flashing, TIMER
icon and a relevant time zone code T(1-4)
depending on current time are on
TIMER programming is finished.
and
and pressing the
button (or when in 24 hour TIMER
buttons at the same time until
Werbung
