TERMA SKT 1 Gebrauchsanweisung Seite 71

9. Extension leads or electric plug adapters should not be used in order
to supply power to the heater.
10. While connecting the radiator to electric installation ensure that the
cur cuit has a 30 mA residual-current circuit breaker and an appropri-
ate over current circuit breaker. With the permanent installation (cable
connec tion without plug) it is also mandatory to have an omni-pole
cut-out for disconnecting the device on all poles, by points of contact
with the clearance of 3 mm.
11. The device version labelled F can be installed in bathrooms in zone
1, as defined by applicable law, subject to any additional regulations
concerning electrical installations in wet areas. Other versions of
the device can be installed in Zone 2 or beyond.
12. The device is recommended for use solely as described in the manual.
EN
User Manual — Electric heating elements of the SKT series
71