TERMA SKT 1 Gebrauchsanweisung Seite 85

Setting 1 Setting 2 Setting 3
TIMER mode
TIMER Mode is activated by pressing the button
turns on).
1. TIMER Mode can be used to TURN OFF the device:
Press button while the device is on — the device will turn
off after 2 hours.
2. TIMER Mode can also be used to TURN the device ON:
Turn the device off using the button
the device will turn on after 2 hours, with the same tempera-
ture it was set to prior to being turned off. If the required tem-
perature is different to the one from before when the device
was turned off, set the required temperature before turning the
device off.
TIMER Mode can be turned off in at any time by pressing button.
EN
ANTI-FREEZE function
When the device is off or in the TIMER mode but still has a live
feed, and the temperature inside the room falls down below 6°C
Setting 4 Setting 5
the device will automatically turn on and start heating. This function
will prevent the heating medium inside the radiator from freezing.
Yellow diode is flashing until the temperature reaches 6°C.
(yellow diode
FIL-PILOTE INTERFACE
Selected versions of SKT-2 are equipped with a FIL PILOTE inter-
face which enables remote heating control through an external
controller which conforms with FIL PILOTE standards.
, press the button —
Signal FP Command
FP-CONFORT
FP-ECO
FP-AF
FP-STOP
User Manual — Electric heating elements of the SKT series
Reaction of the
Controller
Heating in accordance
with current setting
Reduction of settings
by 1 level (if current
setting equals 1, device
will turn itself off)
No heating, anti-freeze
function is active
Heating mode and
anti-freeze functions
are both off
85