Connection Box Installation And Switching Orientation From Right-Hand To Left-Hand - SystemAir SAVE VTR 100/B Betriebs- Und Wartungsanleitung

12
| Installation
Dashed lines mark the outline of SAVE VTR 100/B unit.
6.2 Connection box installation and switching orientation from Right-hand to Left–
hand
A connection box for accessories is delivered separated from the unit to prevent damage during delivery. Mount the
connection box before proceeding with installation.
1 Pull out a cable from bellow of the connection box
mount plate. It may be necessary unscrew the plate
first to get access to the cable.
2 Insert the cable into the connection box and plug the
cable to the connection board.
3 Insert the connection box into prepared holes on the
plate. Be careful not to pinch the cable. The connec-
tion box should be firmly locked in place.
By default the unit is delivered as a right version model. It can easily be switched to left version if needed.
1 Unscrew the connection box mount plate and a cover
plate on the other side of the unit. These plates have
to be swapped. A cable can be found under the cover
plate. Lead a cable through a hole in the connection
box mount plate. It will be used to connect the con-
nection box to the unit. (figure A)
2 Unscrew the mounting bracket. It has to be installed
on the other side cover (figure B).
GB
212193 | v04