Installation Between Or In A Cupboard Without A Base Using Brackets - SystemAir SAVE VTR 100/B Betriebs- Und Wartungsanleitung

GB
6.4.2.1 Installation between or in a cupboard without a base with a cooker hood attached
directly to the unit
1. Remove the cooker hood filter to access holes at the top of the cooker hood from inside.
Insert included screws (figure 11, pos. 2) into the cooker hood holes, place included plastic spacers on the each pro-
truding screw to prevent over-tightening (figure 11, pos. 3).
2. Place a circular insulation on the cooker hood connector to prevent air leaking (figure 11, pos. 4).
3. Insert the cooker hood duct connector into the unit and tighten the screws.
Screw the cooker hood directly to the bottom of the unit using prepared holes (figure 11, pos. 1).

6.4.2.2 Installation between or in a cupboard without a base using brackets

When the cooker hood cannot be attached directly to the unit, use included brackets. Flexible duct is needed to connect
the cooker hood with the SAVE VTR 100/B unit when using this type of installation.
1.
Mark out and fasten screws so that they protrude a few millimetres from both cupboard sides (figure 12, pos. A). If it
is intended to align the underside of the cooker hood with the underside of the row of cupboards, use the upper
measurement 102; see figure 12, pos. A. The cooker hood brackets are adjustable to fit various cupboard depths (fig-
ure 12, pos. B).
2. Move the cooker hood brackets without fully tightening the screws and adjust the brackets so that they fit the sides
of the cupboards (figure 12, pos. C). Hang the cooker hood in the pre-installed screws in the side of the cupboard.
212193 | v04
Fig. 11 Attaching the cooker hood directly to the unit
Fig. 12 Installation using brackets
21
Installation |