SystemAir SAVE VTR 100/B Betriebs- Und Wartungsanleitung Seite 15

GB
If the wall is from a thick concrete or bricks, no special preparation is needed (figure 5, pos. A), otherwise make nec-
essary adjustments (figure 5, pos. B). The unit weights 39 kg.
Make sure there is a power socket is located nearby the unit, preferably above it. It must be earthed. SAVE VTR 100/
B power cable length is 1,9 m and it comes out from the top left side in right version units and from the right top side
in left version units. Choose power socket location accordingly.
2. Screw the mounting bracket (pos. 1) with the anti-vibration pad (pos. 2) to the wall (figure 6, pos. A). Screws are not
included, choose them based on your wall type. Use appropriate holes to screw the bracket firmly to the wall. Bottom
side of bracket should be 40 mm (H) below top of unit position.
Leave 15 mm gap between the mounting bracket and the cupboard for the cooker hood wires.
Note:
Make sure that the mounting bracket is completely horizontal once mounted on the wall. Check with a spirit
level.
212193 | v04
Fig. 5 Surface preparation.
C — concrete/bricks, W — wood block, G — gypsum, M — mineral wool
Fig. 6 Installation of mounting bracket without or with wooden blocks
15
Installation |