SystemAir SAVE VTR 100/B Betriebs- Und Wartungsanleitung Seite 23

GB
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
Warning
Beware of sharp edges during mounting and maintenance. Use protective gloves.
Consider the unit weight when mounting!
Note:
Make sure that the unit is completely vertical and horizontal once mounted on the wall. Check with a spirit
level.
Make sure there is at least 2 mm gap between the unit and the cupboard to prevent vibration noises.
Mounting the unit with the cooker hood installed using brackets
1. Pull the cooker hood power supply and control cables to the top since the mounted SAVE VTR 100/B unit will block
access to the back.
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
3. Connect the cooker hood and the SAVE VTR 100/B unit using flexible duct.
6.4.3.1 Wiring and configuration
Connect control signal wires from the cooker hood to any
free universal input and 24 V on the external connection
board (figure 4). For more information about connection
board see 8.2 External connections (Connection board),
page 50.
Note:
Configuration of the Cooker Hood Function
can be done only after the first power up of
the SAVE VTR 100/B unit and competed
startup wizard.
212193 | v04
Fig. 14 Placing the unit on the mounting bracket
Fig. 4 Connection of the cooker hood
23
Installation |