Optional Installation In A Cupboard With A Base; Unit Mounting And Cooker Hood Wiring - SystemAir SAVE VTR 100/B Betriebs- Und Wartungsanleitung

22
| Installation
Tighten the screws in the bracket and on the wall (figure 12, pos. D). Lock the brackets into position using the locking
screws (figure 12, pos. E).

6.4.2.3 Optional installation in a cupboard with a base

1.
Using a saw, cut out a hole in the base of the cupboard. When the SAVE VTR 100/B unit is mounted directly on the
wall, the minimum distance from the wall to the hole has to be 55 mm (figure 13, pos. A).
Note:
Be sure to add the thickness (dimension X) of your wooden blocks if they were used (figure 13, pos. B).
2. Attach the brackets as far into the cooker hood as pos-
sible. Insert the cooker hood up into the hole in the
base of the cupboard. Pull out (figure 3, pos. A) and use
screws to fasten the brackets to the sides of the cup-
board (figure 3, pos. B). Tighten the brackets in the
cooker hood.
6.4.3

Unit mounting and cooker hood wiring

Mounting the unit with attached cooker hood
1. Pull the cooker hood power supply and control cables to the top since the mounted SAVE VTR 100/B unit will block
access to the back.
Fig. 13 Dimensions of a hole in the base of the cupboard
Fig. 3 Installation using brackets
GB
212193 | v04