Fitting The Kitchen Furniture Panel As A Door - SystemAir SAVE VTR 100/B Betriebs- Und Wartungsanleitung

26
| Installation
1. Install four M6 bolts into threaded inserts in brackets and lock bolts with hex nuts (figure 17). Bolts protrusion can be
adjusted later.
A cross screwdriver and a 10 mm spanner are needed. They are not included in the package.
Brackets are adjustable vertically (figure 17, A) and horizontally (figure 17, B). Align the brackets with the underside
of the unit. Fully tighten screws after adjusting the brackets.
2. Install four hooks near the edges on the kitchen furniture panel. Sticker with marked holes (figure 18, pos. 1) is in-
cluded with the unit. Holes mark spots for screws to attach hooks. Place the sticker on a back of the kitchen furniture
panel, figure 18, pos. 2). Size of the sticker is the same as the unit. Manually mark out distances from the edges in
case the panel is bigger than the sticker.
Once correct position is found, attach four hooks (figure 18, pos. 3) by fastening each with two screws (figure 18,
pos. 4). Hang the panel on protruding bolts (figure 18, pos. A).
If the kitchen furniture panel does not align with cabinets, take it off and adjust bolts, brackets or hooks.
6.5.3

Fitting the kitchen furniture panel as a door

Another suggested option is to use hinges instead of
brackets and install the kitchen furniture panel as a
hinged cupboard door. Hinges or other needed parts for
this installation method are not included in the package.
Fig. 18 Installation of hooks and mounting of the cover
Fig. 6 Kitchen furniture panel as a door
GB
212193 | v04