Fitting The Hob - KKT KOLBE EB8017ED Benutzerhandbuch

Installation

9.4 Fitting the hob

• Insert the hob into the worktop cut-out,
so that it rests with the seal on the worktop.
Note: The hob is stabilized by its own weight.
Additional mounting accessories such as installation brackets
are not required and are therefore not included in the delivery.
After installation, the connection cable and the
underside of the hob must no longer be accessible.
Installation of heat protection below the hob
If the hob is installed above a drawer, furniture compartment
or similar, or if the hob is accessible from below:
• Install a protective plate of heat-resistant material
(e.g. made of perforated plate to ensure ventilation)
at a minimum distance of at least 50 mm below the hob
(see illustration).
• When using adhesive, make sure that the temperature
resistance is 150°C.
76
!
min.50mm
max.5mm max.5mm