KKT KOLBE EB8017ED Benutzerhandbuch Seite 138

Troubleshooting
Problem
The touch controls are
difficult to operate.
The cookware is not
heated and
is displayed.
The hob is not working
and the cooking zone
displays show
Heating takes an
unusually long time.
The hob switches off
unexpectedly.
The hob switches off or
off unexpectedly.
70
Possible cause
There is a slight
film of water on the
controls.
The fingertip is used
for operation.
The cookware is
not suitable for
induction or is not
detected.
There is moisture /
spilled liquid or
.
staining on the
control panel
Unsuitable cookwa-
re is used.
Fluctuations in
the power supply
system
The overheating
protection was
triggered.
The control panel
has been touched in
an uncontrolled way
What to do
Make sure the touch control area
is clean and dry.
Use the ball of your finger
when touching the controls.
Use induction-suitable cookware
in a size suitable for the desired
cooking zone and position it correctly.
See cookware chapter.
Clean and dry the control panel.
After a few seconds, the display will
disappear and you can use the hob
again normally.
If you do not do this, the hob will auto-
matically switch off.
Use cookware with a high proportion
of magnetic particles (see chapter on
cookware).
Even fluctuations of 10 volts in the
mains supply can lead to a much longer
cooking time.
Make sure that the cookware does
not protrude over the cooking zone
markings in the direction of the control
panel to prevent it from overheating.
Take care not to place anything on the
control panel and not to drag or wipe
anything over it.
If necessary, switch the hob back on
and use it as described.