Auto/Eco Mode; Checking The Charge Status Of The Battery; Working With The Device - Parkside PRMA 40-Li C1 Originalbetriebsanleitung

GB
4. Before switching the apparatus
on, make sure that it is not touch-
ing any objects.
5. To switch the device on, press
the release button (16) and hold
it down while pulling the start
handle (17). Let go of the release
button.
6. To switch the apparatus off, let go
of the starting lever (17).
Due to the intelligent energy man-
agement system, the motor starts
after a delay.
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.

Auto/Eco mode

The cordless lawnmower automatically
launches in the last mode used when
turned on. Pressing the switch button (20)
lets you switch between Auto, Eco and
Turbo mode.
The LED display (21) lights up to show you
which mode the cordless lawn mower is in.
Auto mode: The cordless lawn mower
adjusts the motor speed in
accordance with the load.
Eco mode:
The cordless lawn mower
runs at the lowest speed for
maximum battery life.
Turbo mode: The cordless lawn mower
starts at high speed. If the re-
sistance is too low, the motor
speed is adjusted.
32
Checking the charge status
of the battery
The charge level indicator (
the charge level of the batteries (
ing operation or when you press the switch
button ( 20).
The charge level of the battery is indicated
by illumination of the corresponding LED
lights.
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged

Working with the device

Observe noise protection rules and
other local regulations.
Regular mowing stimulates the grass to an
increased leaf formation, while at the same
time killing weeds. Therefore, the lawn be-
comes denser after each mowing process,
resulting in an evenly loadable lawn.
The first cut takes place roughly in April
when the grass is about 70 - 80 mm high.
During the main growing season, the lawn
is mowed at least once a week.
• Move the device at walking speed and
in lines which should be as straight as
possible. For a flawless mowing result,
the lines should always overlap by a
few centimetres.
• Adjust the cutting height so that the de-
vice is not overloaded. If this not done,
the motor may become damaged.
22) signals
9) dur-