Maintenance And Storage; Initial Start-Up; Mounting The Lower Bar; Mounting The Handlebar - Parkside PBM 125 A1 Originalbetriebsanleitung

GB IE

Maintenance and storage:

• Make sure that all nuts, bolts and
screws are properly tightened, and that
the device is in safe working order.
Many accidents are caused by poorly
maintained appliances.
• Never store the device with fuel in its
petrol tank inside a building, where
fuel vapours may be coming in contact
with fire or sparks.
• Give the engine time to cool off before
you store the device in an enclosed
space. Possible fire hazard.
• To avoid risk of fire, keep engine,
exhaust and the area around the petrol
tank free of grass, leaves or leaking
grease (engine oil).
• Check the grass collection unit regular-
ly for wear or loss of function.
• Replace worn or damaged parts for saf-
ety reasons. Replace defective mufflers.
• If you need to drain the petrol tank,
you must do so outside.
• Treat your device with care. Keep the
tools sharpened and clean in order to
be able to work better and safer. Fol-
low the maintenance instructions.
• Do not try to repair the device yourself,
unless you have professional training. All
work not specified in this instruction ma-
nual may only be carried out by custo-
mer service centres authorised by us.
• Store the device in a dry place and out
of reach of children. Devices can be
dangerous if operated by inexperien-
ced persons.

Initial start-up

Caution! Risk of injury due to
rotating blade. Only perform
work on the device when the
engine is switched off and
has come to a stop.
34
Please observe the delivered inst-
ruction manual from Briggs & Strat-
ton.
Before starting the device, you must
- Remove all transport safety devices,
- fold up the grip rod and lock the quick
release levers,
- fill the engine oil,
- fill the petrol,
- mount the grass collection box if neces-
sary,
- set the cutting height if necessary.

Mounting the lower bar

Make sure that the Bowden cable
( 3) is not crushed during the
assembly of the grip rod.
1. Fold the lower bar (4) up.
2. Turn the quick release levers (7) cross-
wise towards the bar. Gently pull the
quick release levers (7) away from the
lower bar (4).
3. Move the lower bar (4) to the desired
position.
There are three possible positions.
4. Turn the quick release levers (7) back to
their original position. The quick relea-
se levers click into place.

Mounting the handlebar

1. Place the handlebar (1) onto the lower
bar (4).
2. Slide a screw (5c) through the holes on
the grip rods on both sides.
3. Slide one washer (5a) on each of the
screws (5c). The grooved side of the
washer (5a) should face the handlebar
(1).
4. Screw the quick release levers (5b) on
the screws (5c).