Maintenance And Storage - Parkside PRM 1800 A1 Originalbetriebsanleitung

GB
MT
which it is designed.
• Do not use the equipment near
inlammable liquids or gases.
Non-observance will result in a
risk of ire or explosion.
• Do not lift or carry the equip-
ment when the motor is running.
Risk of injury from cuts.
• Switch off the equipment and
disconnect the plug. Make sure
that all moving parts have come
to a complete stop:
- Whenever you leave the ma-
chine,
- Before cleaning the ejection
hole or removing blockages,
- When the equipment is out of
use,
- Before checking, cleaning or
working on the equipment,
- If the power cable is dam-
aged or frayed,
- if a foreign object has been
hit by the device. Check for
damage to the lawnmower
and carry out the necessary
repairs before switching on
again and working with the
lawnmower.
If the lawnmower starts to vi-
brate abnormally, an immedi-
ate check must be carried out.
- carry out a search for damage;
- perform the necessary repairs
of damaged parts;
- make sure that all nuts, bolts
and screws are properly tigh-
tened.
• Do not place feet or hands near
or under rotating parts. Do not
stand in front of the grass ejec-
tion hole during mowing.
28

Maintenance and Storage:

• Ensure that all nuts, bolts and
screws are tightened irmly and
the equipment is in safe work-
ing condition.
• Do not attempt to repair the
equipment yourself unless you
have been trained to do so.
Any work not speciied in these
instructions is to be carried out
only by customer service centres
that we have authorised.
• Keep the equipment in a dry
location and out of reach of
children.
• Handle the equipment with
care. Keep tools sharp and
clean, in order to facilitate bet-
ter and safer work. Follow the
maintenance instructions.
• Wear protective gloves when
changing the cutting device.
• Regularly check the grass col-
lection device for wear and
strains. For safety reasons, re-
place worn or damaged parts.
When adjusting the blades,
particular care to avoid in-
take
gers being trapped between the
rotating blades and ixed parts
of the machine.
Many accidents are caused by
poorly maintained equipment.
• Check that only replacement
tools authorised
facturer are used.
• During maintenance of the cut-
ting blades, be aware that they
can be brought into motion
even when the power supply is
switched off.
• Worn or damaged information
signs must be replaced.
by the manu-