Mulch Kit; Operation; Mounting/Removing The Grass Collection Box; Filling Level Indicator - Parkside PRMA 40-Li A1 Originalbetriebsanleitung

GB
2. Place the plastic tabs (13a) of the
grass collection box (13) over the
grass collection box rods (13b).

Mulch kit

Attaching the mulch kit
1. Remove the grass collection box, if
used.
2. Lift the impact protection.
3. Slide the mulch kit (18) into place. The
bracket (18a) snaps into place.
Removing the mulch kit
4. Push in the bracket (18a) on the mulch
kit and remove the mulch kit (18).

Operation

The device must only be
adjusted when the motor is
switched off and the blade is
stationary. There is a risk of
personal injury.
Switch off the apparatus, remove
the ignition key (
for the blades to come to a stand-
still.
Mounting/removing the
grass collection box
1. To mount the grass collection box
(13), lift the impact protection (4) and
suspend the grass collection box (13)
from both receptors.
2. Fold the impact protection (4) over the
grass collection box (13). This will hold
the grass collection box in the correct
position.
3. To remove the grass collection box
(13), lift the impact protection (4) and
remove the grass collection box (13).
12
10) and wait
Fold the impact protection (4) back
over the device housing (12).
Work may not be carried out
using the device without the
impact protection or grass
collection box. There is a risk
of injury.

Filling level indicator

There is a filling level indicator (
the side of the grass collection box (
Filling level indicator open:
Grass collection box empty.
Filling level indicator closed:
Grass collection box filled.
Setting the cutting
height
The apparatus has 6 positions for adjusting
the cutting height:
35 mm/25 mm - low cutting height
55 mm/45 mm - medium cutting height
75 mm/65 mm - large cutting height
1. Hold the carrying handle (
lift the device or push the device down.
2. Grip the lever (7) for adjusting the cut-
ting height and move it past the ratchet
mechanism to the desired cutting
height.
The correct cutting height is between 25
and 45 mm for an ornamental lawn and
about 45 - 65 mm for a utility lawn.
A high cutting height should be
selected for the first mowing of the
season.
26) on
13).
6) and