Charging Process; Removing/Inserting The Battery; Checking The Charge Status Of The Rechargeable Battery - Parkside PRMA 20-Li A1 Originalbetriebsanleitung

Charging Process

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charg-
er, check that the battery's
outer surface is clean and
dry.
There is a risk of injury due
to electric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
The rechargeable battery only
reaches its full capacity once it has
been charged several times.
Only charge with the originally sup-
plied charger.
• Charge the battery before the fi rst time
of use. Do not briefl y recharge the bat-
tery several times in a row.
• Only charge with the originally sup-
plied charger.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
Battery
1. To remove the battery (4) from the ap-
pliance, press the release button (1) on
the battery and pull out the battery.
2. To insert the battery (4), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.
Only insert the rechargeable
battery once the device is
completely assembled. Risk
of injury!
Checking the charge status
of the rechargeable battery
The battery charge status indicator (3)
signalises the state of charge of the battery
(4).
Press the button (2) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery (4) when
the red LED on the charge status
indicator (3) is on.
GB IE
19