Disposal And Recycling - Scheppach P-MGB5-1 Anleitung

Storing the equipment
If you intend to store the equipment for longer than 30 days, the equipment must be prepared accordingly. Oth-
erwise the fuel still remaining in the carburetor will evaporate and leave a rubbery sediment. This can cause
problems when starting up the equipment and may require expensive repairs.
1 Slowly remove the fuel tank cap to release any pressure that may have formed in the tank. Carefully empty
the tank.
2 To remove the fuel from the carburetor, start the engine and let it run until the equipment stops.
3 Leave the engine to cool (approx. 5 minutes).
4 Remove the spark plug (see section 10 Change and clean the spark plug).
5 Add one teaspoon of 2-stroke engine oil into the combustion chamber. Slowly pull the starter cord several
times to apply a layer of oil to all internal components. Fit the spark plug again.
Note: Store the equipment in a dry place and far away from possible ignition sources such as an oven, a gas-fi
red hot water boiler, a gas-fi red dryer, etc.
Putting the equipment back into operation
1 Remove the spark plug (see section 10 Change and clean the spark plug).
2 Quickly tug on the starter cord to remove excess oil from the combustion chamber.
3 Clean the spark plug and check that the electrode gap is correct, or insert a new spark plug with the cor-
rect electrode gap.
4 Prepare the equipment for operation.
5 Fill the tank with the relevant mixture of fuel and oil. See the section „Fuel and oil".
Transport
To transport the machine, empty the petrol tank as described in section 8 draining fuel. Clean coarse dirt off the
equipment with a brush or hand brush.
Always attach the transport guard to all cutting tools. Fig. 1 (14a, 15a, 17a)
In order to prevent damage and injury, secure the tool against tipping over and sliding when transporting it in
vehicles.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it from being damaged in transit. The raw ma-
terials in this packaging can be reused or recycled. The equipment and its accessories are made
of various types of material, such as metal and plastic. Defective components must be disposed
of as special waste. Ask your dealer or your local council
64 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
.