Maintenance - Scheppach P-MGB5-1 Anleitung

Do not tilt the rail to the side when you pull them out of a cutting gap, since the chain could get
caught otherwise.
Operation Leaf blower
Do not smoke while refueling or operating equipment.
•
Do not touch or let your hands or body come in contact with a hot muffler or spark plug wire.
•
Due to the danger of exhaust fumes, never operate blower in a confined or poorly ventilated area.
•
Use the tool only in broad daylight or in well-lit conditions.
•
Do not underestimate the forces involved. Make sure you stand squarely and keep your balance
•
at all times.
If possible, avoid using the tool on wet grass.
•
Ensure that you maintain a steady foothold particularly while working on slopes.
•
Always walk. Never run.
•
Always keep the ventilation opening clean.
•
Never direct the blow hole at persons or animals.
•
The machine may only be used at reasonable times of the day, i.e. not in the early morning or
•
late evening when it will be a nuisance to other people. Permitted times of use specified by local
authorities must be observed.
The machine must be run at the lowest possible motor speed required to carry out the work.
•
Remove all foreign objects with a rake and brush before starting any blowing work.
•
Where conditions are dusty, dampen the surface a little or use a sprinkler attachment.
•
Use the full-length blower nozzle extension so that the air current can work near to the ground.
•
Watch out for children, pets, open windows etc. and blow the foreign objects safely away from
•
them.
If the device makes abnormal noises or has unusually high levels of vibration, it must be checked.
•
Unusually high levels of vibration can injure the operator and damage the unit.
Never operate the appliance with defective guards or shields, or without safetydevices, for ex-
•
ample debris collector in place
Do not expose the hot engine to flammable materials
•
The Blower can be used to blow debris from patios, paths, driveways, lawns, bushes and borders.
•
Select the blow function using the selector lever on the side of the machine and switch on.
•
Alternatively hold nozzle just above the ground and swing the machine from side to side, moving
•
forwards and direct the nozzle at the debris to be cleared.
Blow the debris into a convenient heap
•

10. Maintenance

WARNING: Always wear protective gloves when working on or around cutting tools. For non-use,
transport or storage always attach the transport guard to all cutting tools. Fig. 1 (14a, 15a, 17a)
Before performing any maintenance or cleaning work, always turn off the engine and pull out the
spark boot plug.
1. Do not spray the unit with water. It damages the engine.
2. Clean the unit with a cloth, hand brush, etc.
3. Use a moist piece of cloth to clean the plastic parts. Do not use any cleaning agents, solvents, or
sharp objects.
58 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58