Scheppach P-MGB5-1 Anleitung Seite 62

Oiling the gears (pole saw)
Oil the gears every 10 to 20 operating hours.
1 Position the grease gun at the lubricating nipples Fig. 47 (Q).
2 Insert some grease.
Attention! Fill only a small amount of grease. Do not overfill.
Check the hedge trimmer for obvious faults such as:
• loose attachments
• worn or damaged components
• bent, broken or damaged cutting tools
• correctly attached and working covers and safety devices
• wear, in particular, cutting tool play
Immediately replace damaged or blunt cutting tools, even in the event of minor damage.
Oiling the gears, hedge trimmer
Oil the gears every 10 to 20 operating hours.
1 Position the grease gun at the lubricating nipples Fig. 41 (P).
2 Insert some grease.
Attention! Fill only a small amount of grease. Do not overfill.
Oil the cutting tools and the angle adjustment with environmentally friendly lubricant.
Adjusting the idle speed Fig. 50
If the cutting device runs idle, correct the idle speed.
1. Allow the engine to warm for 3-5 minutes
(No high speeds!).
2. Turn the adjusting screw (S):
clockwise
- idle speed increases (+)
counterclockwise
- Idling speed decreases (-)
The idle speed is 3000 min
Contact the manufacturer if the cutter continues to run at idle.
Do not continue to operate the unit!
The user is responsible for all damages caused by non-compliance with instructions in this
manual.
This also applies to non-authorized modifications of the tool, use of non-authorized spare
parts, accessories, working tools, unrelated and not intended use, secondary damages due
to use of faulty components.
Wear Parts
Even when used in the intended way, some components are subject to normal wear. They have to
be replaced depending on the kind of duration of usage. These parts include, among others, the
cutting tool and the retaining disk.
m Warning! Use only original manufacturer's replacement parts, accessories and attachments.
62 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
-1