Attachment And Operation - Scheppach P-MGB5-1 Anleitung

Never use oil for 4-cycle engine or use water cooled 2-cycle engine. It can cause spark plug foul-
ing exhaust part blocking or piston ring sticking.
Mixed fuels, which have been left unused for a period of one month or more, may clog the carbu-
retor or result in the engine foiling to operate property. Put remained fuel into an airtight container
and keep it in the dark and cool room.
Fuel mixing table
Mixing procedure: 40 parts petrol to 1 part oil
Example:
1 l Petrol : 0,025 l 2-stroke oil
5 l Petrol : 0,125 l 2-stroke oil
Warning!
Take care of the emission of exhaust gases.
Always shut off engine before fueling. Never add fuel to a machine with a running or hot
engine. Take care of fire!Only ever refuel the tool outdoors or in sufficiently ventilated
rooms. Make sure not to spill fuel or chain oil into the soil (environmental protection). Use
a proper base.

8. Attachment and operation

ASSEMBLY
When assembling this machine, please follow the instructions for assembly printed.
1. Assemble the handle on the machine. Fig. 2-3
• Install the front handle as shown on the image 2.
• Make sure that you align the pin with the hole. Tighten the screws only loosely before you have
the most comfortable working position set to the risers. The front handle should be aligned as in
pictures 2+3 shown, then tighten the screws.
2. Mounting the shaft. Fig. 4
• Pull out the locking pin (a) and press the lower part of the shaft (b) downward until the locking
pin engages. The bolt (a) is in the right position when it is fully seated in the bore.
• Lastly, tighten the knob (d) securely.
3. Assemble the safe guard. Fig. 5-7
• Fix the safe guard with hex key and wrench enclosed as stardard accessories for tighting the
nuts enough. Please see the below pictures showing.
m Warning! . Never use the machine without the guard assembled!
4. Assemble and disassemble the cutting head
grass trimmer / nylon cutting head. Fig. 8-9
• Release the nut.
Line up the two holes of flange and shield, use one screw driver to hold the flange as below and
turn the socket wrench clockwise, the nut will be released.
• Fit the Nylon cutting head.
Remove another shield after release the nut. Still hold the flange, take the Nylon cutting head on
the shaft and rotate counter-clockwise, the Nylon cutting head is fitted. Fig. 19
• Release the Nylon cutting head.
50 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58