Scheppach P-MGB5-1 Anleitung Seite 51

Use screw driver to hold flange and then rotate the Nylon cutting head clockwise, it will be re-
placed.
Brush cutter / Cutter blade Fig. 10-12
• Fit the blade.
• Take the outer flange off after release the nut, then put the blade (17), outer flange (17b), shield
(17a) and nut according to priority as below picture. Note the blade rotation direction needs be
same as below picture. Use screw driver to hold flange and tighten nut counter-clockwise, en-
sure the nut is tightened enough.
• Release blade. Use screw driver to hold flange and release nut, the blade can be took off.
m Warning!
Please make sure the cutting head has been assembled correctly before use!
OPERATION
When working with the equipment as grass trimmer and brush cutter, the appropriate plastic guard
hood for cutting blade mode or cutting line mode must be fi tted to prevent objects being thrown
out by the equipment.
The integrated blade (A) in the cutting line guard hood automatically cuts the line to the optimum
length. Fig. 18
5. Fit the belt. Fig. 13-15
• The Combined gasoline grass trimmer, pole saw, brush cutter must be used with the strap.
• Balance the machine when the tool is switched off.
• Wear the shoulder strap.
• Adjust the strap length so that the snap hook (k) is about a hand's breadth below the right hip.
• Hang the petrol brush cutter on a hook.
• Hang the machine.
• When standing in a normal working posture, the blade should touch the ground during normal
working position.
• Thereby, it is important that the petrol brush cutter is always well balanced.
• For operation, hook the petrol brush cutter into the snap hook (k) of the carrying strap while the
engine is running.
• ATTENTION! In an emergency, the safety latch (l) can be pulled from the harness. The machine
then detaches immediately from the carrying strap (9) and falls to the ground.
6. Mounting the hedge trimmer (Fig. 40-42)
• Remove the screw (d), align the holes (c) so that they are flush and screw the screw (d) back in.
• Place the hedge trimmer (15) precisely as shown in Figure 40 on the connecting rod (3).
• Tighten with screw (a).
• Adjust the slope by unlocking the lock (Fig. 41)
• The hedge trimmer can be tilted from 0 ° to 90 ° (Fig. 42).
7. Fitting the cutter bar and the chaine (Fig. 43-45)
• Remove the chain wheel cover (Fig. 45/ Item J) by undoing the fastening nut (Item I). Lay the chain
(Item F) as shown into the groove which runs around the cutter bar (Item E).
• Note the alignment of the chain teeth (Fig. 44). Insert the cutter bar as shown in Fig. 44 into the
mount at the gear unit.
• Place the chain round the chain wheel (Item H). Make sure that the teeth of the chain engage se-
curely in the chain wheel. The cutter bar must be hooked into the chain tensioning bolt (Item G).
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB | 51