Establishing A Connection Via Wlan - Fronius Ohmpilot Bedienungsanleitung

Establishing a There are two options for connecting the Ohmpilot to an existing WLAN network:
Connection via
WLAN Connecting via WPS (WiFi Protected Setup)
1. Press the button on the Ohmpilot 1x. The blue LED flashes (once) for as long as the
2. Press the WPS button on the router within 2 minutes.
3. If the blue LED on the Ohmpilot is now lit steadily, the connection to the network was
4. The inverter automatically searches for the Ohmpilot, with the search process taking
up to 5 minutes. If the red LED is unlit and the green LED is flashing, the Ohmpilot is
working correctly.
Connecting via access point and manual configuration of the WLAN
Settings
1. Press the button on the Ohmpilot 2x. The blue LED flashes (twice) for as long as the
2. Activate the "Ohmpilot" WLAN network on your smart device or PC.
3. Enter the website http://192.168.250.181 or http://ohmpilotW.local in the browser.
4. Select the required network in the WLAN network tab.
5. Click "Save & Connect", and enter the WLAN password.
6. If the blue LED on the Ohmpilot is now lit steadily, the connection to the network was
7. The inverter automatically searches for the Ohmpilot, with the search process taking
88
WPS is active.
successful.
WLAN access point is active (30 minutes). Before the access point is opened, a
search for available WLAN networks is carried out.
Alternatively, the Fronius Solar.web app can also be used to search for the Ohmpilot
in the network.
NOTE! If the required WLAN network is not listed, end access point mode by
pressing the button again and repeat the process.
successful.
up to 5 minutes. If the red LED is unlit and the green LED is flashing, the Ohmpilot
is working correctly.