Fronius Ohmpilot Bedienungsanleitung Seite 81

sensor is installed, an external source (e.g. gas-fired heating) must ensure the minimum
temperature.
As an alternative, the Ohmpilot can also ensure the minimum temperature. This may re-
sult in electricity being sourced from the grid. The maximum temperature must be set on
the heating element thermostat. If heating element 1 (9) does not have a thermostat, the
Ohmpilot can also carry out this task as an alternative (see "Optional settings" section).
However, it is imperative that heating element 2 (11) has a thermostat.
NOTE! At no point can both heating elements be heated simultaneously.
1. The section "Establishing the Data Connection" describes how you can access the
Ohmpilot website.
2. Under heater 1, select "manual" and "1 or 3-phase", as well as the power of the load.
3. Under HEATER 2, select "1 or 3-phase" as the load and the power of the load.
81