Fronius Ohmpilot Bedienungsanleitung Seite 78

1. The section "Establishing the Data Connection" describes how you can access the
Ohmpilot website.
2. Highlight the field "Temperature sensor present"
3. Highlight the field "Adapt day curve"
4. Under "Time from", enter the time from which the minimum temperature should be
adjusted, and the specific minimum temperature.
5. Under "Target temperature", enter the required temperature.
6. Under HEATER 2, select "Activate external source"
Example 1:
If you enter 6.00 am under "Time from" and select 45 °C as the temperature, the heat-
ing will operate from 6.00 am until such time as a temperature of 45 °C is reached. The
external source (e.g. gas-fired heating) will only be activated if the temperature is below
the set value.
78