Disposal And Recycling; Troubleshooting - Parkside PBBPS 700 A1 Originalbetriebsanleitung

WARNING
Avoid skin and eye contact!
Mineral oil products, including oils, degrease the skin. Re-
peated and prolonged contact dries out the skin. The con-
sequences can be various skin diseases. Allergic reactions
are also known.
Eye contact with oil causes irritation. In case of eye contact,
immediately rinse the affected eye with clean water. If irrita-
tion persists, consult a doctor immediately!

15. Disposal and recycling

Information on packaging
The packaging materials are recyclable.
Please dispose of packaging in an envi-
ronmentally friendly manner.

16. Troubleshooting

Fault Possible cause
Incorrect starting procedure.
The engine does not
Incorrectly adjusted carburettor
start, or it starts but
mixture.
does not continue
Sooty spark plug.
to run.
Clogged fuel filter.
Contaminated air filter
The engine starts, but
it does not run at full
Incorrectly adjusted carburettor
power.
mixture.
Engine splutters Incorrectly adjusted carburettor
mixture.
No power under load Incorrectly set spark plug.
Engine runs erratically Incorrectly adjusted carburettor
mixture.
Excessive smoke. Incorrect fuel mixture.
No power under load Chain blunt or chain loose
Engine dies Fuel tank empty or fuel filter incor-
rectly positioned in the tank
Insufficient chain Chain oil tank empty
lubrication (blade and
Oil passages clogged
chain become hot)
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
electrical devices.
Fuels and oils
• Before disposing of the unit, the fuel tank and the engine
oil tank must be emptied!
• Fuel and engine oil do not belong in household waste or
drains, but must be collected or disposed of separately!
• Empty oil and fuel tanks must be disposed of in an environ-
mentally friendly manner.
Remedy
Observe the instructions given in this manual.
Have the carburettor adjusted by the authorised service
centre.
Clean/adjust or replace the spark plug.
Replace the fuel filter.
Remove the filter, clean it and reinsert it.
Have the carburettor adjusted by the authorised service
centre.
Have the carburettor adjusted by the authorised service
centre.
Clean/adjust or replace the spark plug.
Have the carburettor adjusted by the authorised service
centre.
Use the correct fuel mixture (ratio 1:40).
Sharpen the chain or insert a new chain. Tension the chain.
Fill the fuel tank.
Fill the fuel tank completely or reposition the fuel filter in
the fuel tank.
Fill the chain oil tank.
Clean the oiling hole in the blade.
Clean the groove of the blade.
GB/IE/NI/CY/MT
21