Turn The Chain Bar; Storage; Waste Disposal And Environmental Protection - Parkside PKSA 40-Li A1 Originalbetriebsanleitung

Turn the chain bar

Use cut-protection gloves when han-
dling the chain or the chain bar.
The blade (7) has to be reversed regularly
after a working time of approximately 10
hours in order to ensure even wear.
1. Switch off the device and remove the
battery ( 16) before carrying out
any maintenance work.
2. Remove the sprocket chain wheel cov-
ering (13), the saw chain (6) and the
chain bar (7).
3. Turn the blade around its horizontal
axis and install the blade and chain as
described under "Installing the sawing
chain and blade".
When doing so, pay attention to the
correct rotation direction of the saw
chain!
Use the graphical symbol below the chain
sprocket (20) as a guide to the alignment
of the saw chain (6) when the blade is ro-
tated. The illustrated direction of travel on
the blade is no longer true.

Storage

• Clean the equipment before putting it
away.
• Empty the oil tank before longer peri-
ods of non-use. Dispose of waste oil
environmentally correctly (see „Waste
disposal and environmental protec-
tion").
• Put on saw bar protection sheath.
• Store the appliance in a dry place well
out of reach of children
Direction of travel of the
saw chain
Waste disposal
and environmental
protection
Remove the battery from the device and
take the device, battery, accessories and
packaging for environmentally friendly
recycling. Instruction on how to dispose
of the rechargeable battery and charger
can be found in the separate instruction
manual.
Machines do not belong with do-
mestic waste.
• Before disposal, remove batteries from
the device first.
• Hand the device and the charger in to
a recycling point.
• Do not dispose of used oil in the sew-
age system or drains. Dispose of used
oil in an environmentally correct man-
ner - bring it to a waste disposal center.
• Defective units returned to us will be
disposed of for free.
GB IE
53