Roller's Multi-Press 22 V ACC Connected Betriebsanleitung Seite 24

eng
Menu
Show/reset information, open sub-menus/setup and information pages and install a new firmware version.
24
Usage bar B
Display QR code in the OLED display with the right button. Scan the QR code with the mobile terminating device and
change the usage bar of the drive unit in the ROLLER Service Portal.
Usage bar C
Display QR code in the OLED display with the right button. Scan the QR code with the mobile terminating device and
change the usage bar of the drive unit in the ROLLER Service Portal.
Usage bar D
Display QR code in the OLED display with the right button. Scan the QR code with the mobile terminating device and
change the usage bar of the drive unit in the ROLLER Service Portal.
Wi-Fi NOT CONNECTED
Wi-Fi connection not yet established or no stored Wi-Fi network available on the drive unit
Setup
Counter 1
Display: t = operating time
1
n = number of pressings
1
Keep right button pressed for 2 s to reset the counter.
Counter 2
Display: t Display: t Display: t = operating time = operating time
2 2 2 2
n = number of pressings = number of pressings
2 2 2
Keep right button pressed for 2 s to reset the counter.
Total counter
Display: ∑t = total operating time
∑n = total number of pressings
Counter cannot be reset.
Annual inspection and periodic testing
Display: n = total number of pressings (is displayed from 25,000 pressings)
d = time remaining in days until annual inspection and periodic testing
Memory capacity
Display: occupied memory/maximum available memory in MB
eng