Secondary Parameters - LORCH MicorStick 180 ControlPro Bedienungshandbuch

Secondary parameters

16 Secondary parameters
 Call up the secondary parameters by pressing
button 19 for 2 sec.
 Set the desired secondary parameter by turn-
ing control knob 14.
‰ A description of the secondary parameters is
provided in the following table.
 Confirm the secondary parameter by pressing
control knob 14.
Code Secondary parameters
Start energy
StE
Hot start energy
Start time
Stt
Hotstart time
StS Start slope time
PuO Pulse Option
2.E Second energy
PuF Pulse frequency
Pub Pulse duty cycle (% of welding current I1)
dAF Arc Force
AEd Arc end detection
Tab. 1: Secondary parameters
07.19
9 The parameter value flashes.
 Change the value of a parameter by turning
control knob 14.
 Store the change by pressing control knob 14.
‰ Press button 19 to terminate a change with-
out storing or to exit the secondary parameter
menu.
Standard
value
50 %
125 %
0.1 s
1.0 s
0.5 s
OFF
50 %
3.0 Hz
50 %
100 %
100 %
909.4119.9-02
Setting range
1 - 200 %
1 - 200 %
0 - 99.9 s
0 - 99.9 s
0 - 99.9 s
OFF - On
1 - 200 %
0.1 Hz - 5 kHz
1 - 99 %
0 - 200 %
0 - 200 %
Mode
x
x
x
x
x
x x
x x
x x
x x
x
x x
- 33 -