Electrode Welding Process; Tig Welding Process; Access Secondary Parameter; Special Functions - LORCH Handy 180 Control Pro Bedienungshandbuch

Starting up Handy 160 ControlPro
Make sure before turning-on, that the
electrode holder, electrode do not touch
on the welding table, the working piece or
any other object which is conductive. Oth-
erwise an arc will be ignited accidentally.
An accidentally ignited arc can damage
the electrode holder, the welding table, the
working piece or the machine.
14.1

Electrode welding process

Switch on machine
 Turn on the machine at mains switch 2.
 Press key button 19 to select electrode mode.
9 Symbol Elektrode (LED 17) lights up.
 Set the required welding current with turning knob 20.
Ignition
 Touch the workpiece with the tip of the electrode and
lift the electrode a bit.
9 The arc ignites between the workpiece and electrode.
14.2

TIG welding process

Switch on machine
 Turn on the machine at mains switch 2.
 Press key button 19 to set TIG mode.
9 Symbol TIG (LED 18) lights up.
 Set the required welding current with turning knob 20.
Ignition
 Open the valve 17 at the TIG torch.
1
 ÂTouch the workpiece with the tip of the electrode.
Â
 ÂLift the electrode a bit.
Â
9 The arc ignites between the workpiece and electrode.
05.11
2
14.3

Access secondary parameter

 Press key 19 for 2 seconds.
9 The 7-segment-display 16 shows alternating the
parameter-code and the corresponding adjustment
value.
 The adjustment valiue can be set by turning knob 20.
 By shortly pressing key 19 the subsequent parameter
will be displayed.
‰ Following parameter are available.
Parameter
Start current
Start current time
Hotstart
Hotstart time
Tab. 1: Secondary parameters Handy 160 ControlPro
 Press key 19 again for 2 seconds to exit secondary
parameter.
14.4

Special functions

Software-Version

 Press key 19 for 5 seconds.
9 Software-Version will be displayed (i.e.. dsp 2.3, St
1.1).
Master reset
Attention! All personal settings will be
i
lost.
All welding and secondary parameters are
reset to their factory settings (master reset
function).
 Turn off the machine at mains switch 2.
 Press key 19 and keep it pressed.
 Turn on the machine at mains switch 2.
9 The 7-segment-display and all operation displays will
light up shortly to confirm.
Mode
50 % 5...200 %
0,1 s 0...20 s
125 % 5...200 % x
1,0 s 0...20 s x
x
x
- 31 -